| /* Portions are Copyright (C) 2011 Google Inc */ |
| /* ***** BEGIN LICENSE BLOCK ***** |
| * Version: MPL 1.1/GPL 2.0/LGPL 2.1 |
| * |
| * The contents of this file are subject to the Mozilla Public License Version |
| * 1.1 (the "License"); you may not use this file except in compliance with |
| * the License. You may obtain a copy of the License at |
| * http://www.mozilla.org/MPL/ |
| * |
| * Software distributed under the License is distributed on an "AS IS" basis, |
| * WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License |
| * for the specific language governing rights and limitations under the |
| * License. |
| * |
| * The Original Code is the Netscape Portable Runtime (NSPR). |
| * |
| * The Initial Developer of the Original Code is |
| * Netscape Communications Corporation. |
| * Portions created by the Initial Developer are Copyright (C) 1998-2000 |
| * the Initial Developer. All Rights Reserved. |
| * |
| * Contributor(s): |
| * |
| * Alternatively, the contents of this file may be used under the terms of |
| * either the GNU General Public License Version 2 or later (the "GPL"), or |
| * the GNU Lesser General Public License Version 2.1 or later (the "LGPL"), |
| * in which case the provisions of the GPL or the LGPL are applicable instead |
| * of those above. If you wish to allow use of your version of this file only |
| * under the terms of either the GPL or the LGPL, and not to allow others to |
| * use your version of this file under the terms of the MPL, indicate your |
| * decision by deleting the provisions above and replace them with the notice |
| * and other provisions required by the GPL or the LGPL. If you do not delete |
| * the provisions above, a recipient may use your version of this file under |
| * the terms of any one of the MPL, the GPL or the LGPL. |
| * |
| * ***** END LICENSE BLOCK ***** */ |
| |
| /* |
| *--------------------------------------------------------------------------- |
| * |
| * prtime.h -- |
| * |
| * NSPR date and time functions |
| * CVS revision 3.10 |
| * This file contains definitions of NSPR's basic types required by |
| * prtime.cc. These types have been copied over from the following NSPR |
| * files prtime.h, prtypes.h(CVS revision 3.35), prlong.h(CVS revision 3.13) |
| * |
| *--------------------------------------------------------------------------- |
| */ |
| |
| #ifndef BASE_PRTIME_H__ |
| #define BASE_PRTIME_H__ |
| |
| #include <stdint.h> |
| |
| #include "base/base_export.h" |
| |
| typedef int8_t PRInt8; |
| typedef int16_t PRInt16; |
| typedef int32_t PRInt32; |
| typedef int64_t PRInt64; |
| typedef int PRIntn; |
| |
| typedef PRIntn PRBool; |
| #define PR_TRUE 1 |
| #define PR_FALSE 0 |
| |
| typedef enum { PR_FAILURE = -1, PR_SUCCESS = 0 } PRStatus; |
| |
| #define PR_ASSERT DCHECK |
| #define PR_CALLBACK |
| #define PR_INT16_MAX 32767 |
| #define NSPR_API(__type) extern __type |
| |
| /**********************************************************************/ |
| /************************* TYPES AND CONSTANTS ************************/ |
| /**********************************************************************/ |
| |
| #define PR_MSEC_PER_SEC 1000UL |
| #define PR_USEC_PER_SEC 1000000UL |
| #define PR_NSEC_PER_SEC 1000000000UL |
| #define PR_USEC_PER_MSEC 1000UL |
| #define PR_NSEC_PER_MSEC 1000000UL |
| |
| /* |
| * PRTime -- |
| * |
| * NSPR represents basic time as 64-bit signed integers relative |
| * to midnight (00:00:00), January 1, 1970 Greenwich Mean Time (GMT). |
| * (GMT is also known as Coordinated Universal Time, UTC.) |
| * The units of time are in microseconds. Negative times are allowed |
| * to represent times prior to the January 1970 epoch. Such values are |
| * intended to be exported to other systems or converted to human |
| * readable form. |
| * |
| * Notes on porting: PRTime corresponds to time_t in ANSI C. NSPR 1.0 |
| * simply uses PRInt64. |
| */ |
| |
| typedef PRInt64 PRTime; |
| |
| /* |
| * Time zone and daylight saving time corrections applied to GMT to |
| * obtain the local time of some geographic location |
| */ |
| |
| typedef struct PRTimeParameters { |
| PRInt32 tp_gmt_offset; /* the offset from GMT in seconds */ |
| PRInt32 tp_dst_offset; /* contribution of DST in seconds */ |
| } PRTimeParameters; |
| |
| /* |
| * PRExplodedTime -- |
| * |
| * Time broken down into human-readable components such as year, month, |
| * day, hour, minute, second, and microsecond. Time zone and daylight |
| * saving time corrections may be applied. If they are applied, the |
| * offsets from the GMT must be saved in the 'tm_params' field so that |
| * all the information is available to reconstruct GMT. |
| * |
| * Notes on porting: PRExplodedTime corrresponds to struct tm in |
| * ANSI C, with the following differences: |
| * - an additional field tm_usec; |
| * - replacing tm_isdst by tm_params; |
| * - the month field is spelled tm_month, not tm_mon; |
| * - we use absolute year, AD, not the year since 1900. |
| * The corresponding type in NSPR 1.0 is called PRTime. Below is |
| * a table of date/time type correspondence in the three APIs: |
| * API time since epoch time in components |
| * ANSI C time_t struct tm |
| * NSPR 1.0 PRInt64 PRTime |
| * NSPR 2.0 PRTime PRExplodedTime |
| */ |
| |
| typedef struct PRExplodedTime { |
| PRInt32 tm_usec; /* microseconds past tm_sec (0-99999) */ |
| PRInt32 tm_sec; /* seconds past tm_min (0-61, accomodating |
| up to two leap seconds) */ |
| PRInt32 tm_min; /* minutes past tm_hour (0-59) */ |
| PRInt32 tm_hour; /* hours past tm_day (0-23) */ |
| PRInt32 tm_mday; /* days past tm_mon (1-31, note that it |
| starts from 1) */ |
| PRInt32 tm_month; /* months past tm_year (0-11, Jan = 0) */ |
| PRInt16 tm_year; /* absolute year, AD (note that we do not |
| count from 1900) */ |
| |
| PRInt8 tm_wday; /* calculated day of the week |
| (0-6, Sun = 0) */ |
| PRInt16 tm_yday; /* calculated day of the year |
| (0-365, Jan 1 = 0) */ |
| |
| PRTimeParameters tm_params; /* time parameters used by conversion */ |
| } PRExplodedTime; |
| |
| /* |
| * PRTimeParamFn -- |
| * |
| * A function of PRTimeParamFn type returns the time zone and |
| * daylight saving time corrections for some geographic location, |
| * given the current time in GMT. The input argument gmt should |
| * point to a PRExplodedTime that is in GMT, i.e., whose |
| * tm_params contains all 0's. |
| * |
| * For any time zone other than GMT, the computation is intended to |
| * consist of two steps: |
| * - Figure out the time zone correction, tp_gmt_offset. This number |
| * usually depends on the geographic location only. But it may |
| * also depend on the current time. For example, all of China |
| * is one time zone right now. But this situation may change |
| * in the future. |
| * - Figure out the daylight saving time correction, tp_dst_offset. |
| * This number depends on both the geographic location and the |
| * current time. Most of the DST rules are expressed in local |
| * current time. If so, one should apply the time zone correction |
| * to GMT before applying the DST rules. |
| */ |
| |
| typedef PRTimeParameters (PR_CALLBACK *PRTimeParamFn)(const PRExplodedTime *gmt); |
| |
| /**********************************************************************/ |
| /****************************** FUNCTIONS *****************************/ |
| /**********************************************************************/ |
| |
| NSPR_API(PRTime) |
| PR_ImplodeTime(const PRExplodedTime *exploded); |
| |
| /* |
| * Adjust exploded time to normalize field overflows after manipulation. |
| * Note that the following fields of PRExplodedTime should not be |
| * manipulated: |
| * - tm_month and tm_year: because the number of days in a month and |
| * number of days in a year are not constant, it is ambiguous to |
| * manipulate the month and year fields, although one may be tempted |
| * to. For example, what does "a month from January 31st" mean? |
| * - tm_wday and tm_yday: these fields are calculated by NSPR. Users |
| * should treat them as "read-only". |
| */ |
| |
| NSPR_API(void) PR_NormalizeTime( |
| PRExplodedTime *exploded, PRTimeParamFn params); |
| |
| /**********************************************************************/ |
| /*********************** TIME PARAMETER FUNCTIONS *********************/ |
| /**********************************************************************/ |
| |
| /* Time parameters that represent Greenwich Mean Time */ |
| NSPR_API(PRTimeParameters) PR_GMTParameters(const PRExplodedTime *gmt); |
| |
| /* |
| * This parses a time/date string into a PRTime |
| * (microseconds after "1-Jan-1970 00:00:00 GMT"). |
| * It returns PR_SUCCESS on success, and PR_FAILURE |
| * if the time/date string can't be parsed. |
| * |
| * Many formats are handled, including: |
| * |
| * 14 Apr 89 03:20:12 |
| * 14 Apr 89 03:20 GMT |
| * Fri, 17 Mar 89 4:01:33 |
| * Fri, 17 Mar 89 4:01 GMT |
| * Mon Jan 16 16:12 PDT 1989 |
| * Mon Jan 16 16:12 +0130 1989 |
| * 6 May 1992 16:41-JST (Wednesday) |
| * 22-AUG-1993 10:59:12.82 |
| * 22-AUG-1993 10:59pm |
| * 22-AUG-1993 12:59am |
| * 22-AUG-1993 12:59 PM |
| * Friday, August 04, 1995 3:54 PM |
| * 06/21/95 04:24:34 PM |
| * 20/06/95 21:07 |
| * 95-06-08 19:32:48 EDT |
| * 1995-06-17T23:11:25.342156Z |
| * |
| * If the input string doesn't contain a description of the timezone, |
| * we consult the `default_to_gmt' to decide whether the string should |
| * be interpreted relative to the local time zone (PR_FALSE) or GMT (PR_TRUE). |
| * The correct value for this argument depends on what standard specified |
| * the time string which you are parsing. |
| */ |
| |
| /* |
| * This is the only funtion that should be called from outside base, and only |
| * from the unit test. |
| */ |
| |
| BASE_EXPORT PRStatus PR_ParseTimeString ( |
| const char *string, |
| PRBool default_to_gmt, |
| PRTime *result); |
| |
| #endif // BASE_PRTIME_H__ |
